Luxman kadettidekki ja Luxman vahvistin. Yhteishinta 250e. Erikseen 150e kpl.

Hillityn tyylikäs 70-luvun viritinvahvistin.Luxman laatua ,toimii moitteetta ja ulkoasu uudenveroinen.Vintage,retro

Myydään vähällä käytöllä ollut Luxman A-007 -vahvistin. Vaihtoehtoisesti osana pakettia jossa mukana T-007 radiovastaanotin, K-007 kasettisoitin ja D-007 CD-soitin (hinta kaikille 150). Noutu Lauttasaaresta. Specifications:Power output: 35 watts per channel into 8 (stereo)Frequency response: 10Hz to 70kHzTotal harmonic distortion: 0.03%Input sensitivity: 2.5mV (MM), 150mV (line)Digital inputs for DAT and CDDimensions: 360 x 125 x 362mmWeight: 8.6kg

Erittäin hyvässä kunnossa laatuvahvistin. Japanilainen versio 100V.Laadukas muuntaja mukaan. Huolto tehty tammikuussa 2024.CommentaryThis is a bulb-type pre-main amplifier that is the fourth generation of the SQ38 series.50CA10 is used for the output tube, and OY15 type is used for the output transformer.The main amplifier section is based on a Mulard type circuit. In order to make the best use of the features of this circuit, the distortion characteristics in the high-frequency range are improved by improving the details. Furthermore, by inserting a phase correction circuit, the instability of the amplifier caused by the attenuation of the load in the high-frequency range where the impedance of the speaker increases is eliminated.The 2-stage NF-type equalizer and LUX NF-type tone control are used in the preamplifier section.The left and right sides of the tone control are independent, and the bending point can be switched by two points for both low and high frequencies.Equipped with a high filter or low filter.Equipped with the input level setting function of the main amplifier section.There are two speaker outputs.Since the output impedance of the speakers can be selected for each system, the optimum load can be selected even when speakers with different impedances are connected.Model RatingType Tube type pre-main amplifierContinuous effective output 30W + 30W (4 , 8 , 16 )Total harmonic distortion factor 0.7% or less (at maximum output)Frequency characteristic 20 Hz to 20 kHz -1dBInput sensitivity Phono1/2:2.2mVAux1/2/3:200mVMonitor:200mVInput impedance Phono1/2 : 50k Aux1/2/3 : 200k Monitor:200mVSignal-to-noise ratio Phono : 60 dB or moreAux : 70 dB or moreMonitor : 70 dB or higherEqualizer RIAA (deviation within ± 0.5 dB)Crosstalk Channel to channel : 57 dB or moreBetween aux and phono : 55 dB or more65 dB or more between Aux and AuxDamping factor Approximately 15 (1 kHz)Residual noise 1 mV or lessRecording output 200mV/2k Pre-part output 1V/1k Tone control LUX System NF Type with Bending Point Frequency SwitchingHigh-frequency curve point : 3 kHz, 6 kHzLow-range bending point : 300 Hz, 150 Hz Possible to be defeatedHigh-cut filter 5 kHz, 9 kHzLow-cut filter 100 Hz, 50 HzAttachment MAIN section input level setTape monitor switch and terminalDIN standard tape connectorUsed vacuum tubes, etc. Vacuum tube :Diode : 50CA10x4 Pieces6DT8/6AQ8x2 pieces6267x2 Pieces12AX7x4 PiecesDS16Ax4 pcs4 DS16CxsPwer 100 VAC, 50Hz/60HzPower consumption 250W at maximum outputExternal dimensions Width 476x Height 190x Depth 335 mmWeight 18kg

Erittäin siisti laatulaite. 80-luvulta.

Lisätiedot Hyvässä kunnossa vahvistin. Täysin ehjä. Huollettu maaliskuussa 2023. Japanilainen versio 100v + 220v muuntaja mukaan.Commentary　The stereo Integrated Amplifier which adopted the Duo beta circuitry.The Duo beta circuitry original with Lux is adopted as equalizer amplifier and power amplifier.The Duo Beta circuit consists of a moderate amount of NFB and DC servos. First, based on an amplifier circuit with excellent bare characteristics, TIM distortion is reduced by applying an appropriate amount of NFB, contributing to the reproduction of sound quality and atmosphere in the mid-high range. And in the DC servo, the problem of intermodulation distortion and DC drift caused by harmful ultra-low frequency components is solved, and at the same time, an excellent speaker braking effect is obtained.High-gain-ization of the equalizer is realized by the duo beta circuit, and not only the MM cartridge but also the MC cartridge can be directly connected to the equalizer.The circuit consists of a cascode differential input first-stage circuit with a bootstrap by low-noise FET and an output stage of class-A single-ended push-pull circuit adoption, and has excellent nakedness characteristics.Furthermore, since the gain of the equalizer itself is high, we have also succeeded in banishing the flat amplifier that causes sound quality deterioration.(Although the input sensitivity of the MC input terminal is 0.3mV and most MC cartridges can be connected, it is recommended to use a high impedance type as much as possible.) The output stage has a high ft (high cutoff frequency). , Cob (collector output capacity) and low large-sized power transistors are carefully selected and used, the speed of the driver circuit is also increased, and the switching distortion is banished.In addition, a newly developed loop-type heat pipe is used to enhance the heat dissipation effect.The line straight composition is adopted and faithful transmission is enabled by setting it as the composition which directly connected the MC equalizer part and the power amplifier part.LUX scheme NF type tone control is adopted as tone control.The turnover frequency can also be switched in two steps for each of high and low frequencies, and a complete bypass is also possible if the defeat position is used.The 10 element right-and-left independent type indicator which displays a peak power in real time is carried.The watt display which can read an output directly is adopted, and it is also possible to turn off with a switch when unnecessary.Two tapes monitors, a dubbing switch, a subsonic filter, and a high cut filter are carried.Model ratingModel integrated amplifierContinuous effective output 70W+70W (8, both channel operation, 20Hz-20kHz)Total harmonic distortion 0.03% (8, 70W, 20Hz-20kHz)intermodulation distortion 0.03% (8, 70W, 60Hz:7kHz=4:1)Frequency characteristic Phono MM, MC: 20Hz - 20kHz ±0.3dBTuner, AUX: 10Hz - 100kHz -1dBInput sensitivity/impedance Phono MM: 1.2mV/50kPhono MC: 0.3mV/100Tuner, AUX: 190mV/50kSN ratio (IHF-A) Phono man-month: 77dBPhono MC: 71dBTuner, AUX: 105dBsubsonic filter 15Hz, 30Hzhigh cut filter 9kHz, 15kHzAC outlet switched: 2 systemsunswitched: 1 systempower consumption 250WExternal dimensions Width 466x height 145x depth 333mmweight 12kg

Erittäin hyvässä kunnossa vahvistin. Täysin ehjä. Huollettu elokuussa 2023. Japanilainen versio 100v + 220v muuntaja mukaan.SpecificationsPower output: 100 watts per channel into 8 (stereo)Frequency response: 10Hz to 100kHzTotal harmonic distortion: 0.007%Input sensitivity: 0.125mV (MC), 2mV (MM), 310mV (line)Signal to noise ratio: 67dB (MC), 84dB (MM), 110dB (line)Dimensions: 453 x 444 x 161mmWeight: 17kg

Erinomaisessa kunnossa vahvistin. Täysin ehjä. Huollettu maaliskuussa 2023. Japanilainen versio 100v + 220v muuntaja mukaan.Power Output: 100W + 100W (8 ohms, both ch. Driven 20Hz 20kHz)T.H.D.: no more than 0.007% (8 ohms, 8W, 20 20kHz)Rated I.M.: no more than 0.007% (8 ohms, 8W, 20 -20kHz) 2mVInput Sensitivity:Phono (MM): 2mVPhono (MC): 125 µVTuner: 310 mVAux: 310 mVMain in: 310 mVInput Impedance:Phono (MM): 50 kohms, 100 kohms, 100 ohmsPhono (MC): 100 ohms, 40 ohms, 300 ohmsTuner: 40 kohmsAux: 40 kohmsMain in: 47 kohmsSignal-to-Noise Ratio (IHF-A weighted):Phono (MM): better than 84dB (input short-circuited)Phono (MC): better than 67dB (250µV input)Tuner: better than 110dB (input short-circuited)Aux: better than 110dB (input short-circuited)Main in: better than 110dB (input short-circuited)Frequency Response:Phono (MM, MC): 20 Hz 20,000Hz (within ±0.2dB)Tuner, aux: 10Hz 100,000Hz (within -1dB)Main in: 10Hz 100,000Hz (within -1dB)Tone ControlMaximum variable amount: ±8dBBass Turnover: 77Hz, 120Hz, 200Hz, 330Hz, 550HzFrequencies: 880HzTreble Turnover: 880Hz, 1.5kHz, 2.5kHz, 4kHz, 6.5kHzFrequencies: 10kHzPreamplifier Output: 310 mVMitat: L453 x S460 x K174 mm. Paino: 18 kg

Tarpeettomaksi jäänyt, Luxman PD-210 manuaalinen vinyylisoitin, jossa Glanz 31L äänirasia.Soittimessa rca-liitoskaapelit.Varaosia edelleen saatavilla mm vetohihnoja yms.Myyn koko paketin 100, mutta erikseen soitin tai äänirasia 60/kpl.

Ihan hyvässä kunnossa setti ja täysin toimiva. Vahvistin A-007, CD-soitin D-007, viritin T-007 ja tupla kasettidekki K-007. Mukaan kaukosäädin ja kaikki välijohdot. Hyvä ääninen sarja.SpecificationsPower output: 42 watts per channel into 8 (stereo)Frequency response: 15Hz to 80kHzTotal harmonic distortion: 0.07%Input sensitivity: 2.5mV (MM), 150mV (line)Signal to noise ratio: 80dB (MM), 92dB (line)Output: 1V (Pre out)Speaker load impedance: 4 (minimum)Digital inputs: coaxial, opticalDimensions: 360 x 125 x 362mmWeight: 8.6kgAccessories: RA-007 remote control