Nyt edullisesti uudenveroinen Savotan sissiteltta, pohjavaate ja kamina, mukaan myös Keskisalko, salkosarja kulmiin ja maakiilat eli valmis paketti kaikenlaiseen eräilyyn tai vaikka metsästys tukikohdaksi. Säilytetty lämpimässä. Hinnassa pieni tinkivara!

Ilmainen J. kotiintoimitus suureen osaan yli 5000€ arvoisia ajoneuvojamme (arvo 200€ ). Lisätietoa myyjiltämme., ohjaamo Ilmastointi, Jääkaappi, Kasetti WC, Kasettiverhot, Liesi, Markiisi, navigaattori, Parivuode, Pesuallas, Stereot, ABS-jarrut, Erikoisvanteet, Huoltokirja, Sähköpatruuna, Trumatic, Kosteusmitattu 5/2021, iso takatalli, OSTAMME myös suoraan henkilö-, paketti- ja matkailuautoja sekä asuntovaunuja. Kysy tarjous!

Suomen armeijan kaasunaamari laukku. Ehjä ja hyväkuntoinen. Hinta 10

Lisätiedot Myydään SA-sukset eli metsäsukset. Pituus 210 cm, leveys 7 cm ja painoluokka 80-100 kg. Sukset ovat käytetyt, mutta hyväkuntoiset.

Myydään SA-sukset eli metsäsukset. Pituus 210 cm, leveys 7 cm ja painoluokka 80-100 kg. Käytetyt, mutta hyväkuntoiset. Pohjan pitoalue suomukuvioinen.

Myydään SA-sukset eli metsäsukset. Pituus 210 cm, leveys 7 cm ja painoluokka yli 100 kg. Pohjan pitoalue sileä. Käytetyt, mutta hyväkuntoiset. Suomen Puolustusvoimien ylijäämää.

Hotellitason laatua:uudet Finlaysonin puuvillatyynyliinat.100 % puuvillaa.Valmistettu Suomen armeijalle:tehty kovaan käyttöön ja kestämään.Hinta:5 euroa kappale.Yli 100 euron tilaukset postikuluitta.***Saatavilla koot:55 x 70 cm65 x 80 cm*** siirry TÄSTÄ tilaamaan

Hyvin palvellut äänirasia (kotikäytössä noin 10 vuotta) ja neula (käytössä noin 20h) uuteen kotiin. Postitus 5eur.

Lisätiedot Ihan siisti ja täysin ehjä vahvari. Huollettu elokuussa 2023.100V laite ja muuntaja mukaan.CommentaryA stereo pre-main amplifier developed by inheriting the design philosophy of SA-9900.Like SA-9900, it adopts a side terminal system in which input / output terminals are arranged on the left and right panels.As a result, the input terminal is completely integrated with the equalizer board to prevent degradation of the high-frequency characteristics caused by the shielding wire.The power amplifier section uses a pure complimentary service OCL circuit directly connected to all stages. It consists of a single stage differential with ± 2 power supplies and a parallel push-pull configuration.By making the load of the pre-driver constant current, the bare gain is increased, and by applying the optimum NFB, the distortion is reduced over a wide band. By using the power supply before the output stage as a stabilizing power supply, the transient crossover distortion at minute outputs is eliminated. By using the parallel push-pull output stage, the linearity of current characteristics is improved and distortion is reduced.In addition, a differential amplifier and a bias compensation circuit are adopted to improve stability, so that fluctuation of offset voltage due to external temperature change is minimized.The equalizer is equipped with a differential amplifier using a low-noise transistor can-shielded at the first stage to stabilize the output mid-point and improve the SN ratio. In addition, 100% DC NFB is applied to reduce distortion and improve stability.In addition, the final stage SEPP operates in class A operation until large amplitude, enabling high output voltage to be extracted at a low distortion rate.In addition, carefully selected high-precision elements are used to improve sound quality.There are two Phono inputs, one of which is capable of level adjustment up to -12dB and 4-point switching of input impedance.For level adjustment, NFB changes up to -6dB, and output volume changes from -6dB to -12dB.The tone circuit is a 2-stage direct-coupled circuit. By using FET in the first stage, noise variation due to volume position is minimized. In addition, NFB is applied to the 2-stage direct-coupled circuit in both AC and DC, and is sent to the tone circuit in the next stage with low impedance, making it an ideal condition for tone circuit operation.In addition, the voltage at the midpoint is stabilized by two power supply systems, plus and minus 24 v (total 48 v).The volume uses a full-scale attenuator type volume with 22 contacts, and the use of high-precision printing resistors reduces gang errors.It also has a 3-step lever type attenuator.NFB type tone control is adopted, and 3-step turnover frequency switching is adopted to expand the control range.It is also equipped with a tone on/off switch.It is equipped with a duplicate switch that can dub tapes 1 to 2 and 2 to 1.The power supply section is equipped with two large electrolytic capacitors of 18,000 F.Equipped with low filter / high filter.A protective circuit with a built-in relay is mounted to suppress noise when power is turned on/off.The actual measurement data of each product is attached.Model RatingType Stereo pre-main amplifierPower Amplifier UnitCircuit system Differential 1-stage all stages directly connected parallel PP pure complimentary service OCLEffective output (both channels driven, 20 Hz to 20 kHz) 100W + 100W (4 )80W + 80W (8 )Harmonic distortion factor (20 Hz to 20 kHz) 0.1% or Less (Effective Output)0.05% or Less (8 at 40W Output)0.05% or Less (8 at 1W output)Cross modulation distortion factor 0.1% or Less (Effective Output)0.05% or Less (8 at 40W Output)0.05% or Less (8 at 1W output)Output Bandwidth (IHF, both channel drives) 5 Hz ~ 40 kHz (Distortion Factor 0.1%)Frequency characteristic 10 Hz to 80 kHz + 0 -1dBInput Sensitivity / Impedance Power amp in : 1V/50k Output terminal Speaker A / B : 4 ~ 16 Speaker A + B : 8 ~ 16 Headphone : 4 ~ 16 Damping factor (20 Hz to 20 kHz) 30 or moreS/N 100 dB or more (IHF, A-network, short circuit)Preamplifier SectionCircuit system Equalizer amplifier : A class SEPP with 2 positive and negative power supplies, one stage differential and three stage direct connectionControl amplifier : Positive and negative 2 power supply, first stage FETInput Sensitivity / Impedance Phono1 : 2.5mV/50k Phono2 : 2.5 to 10mV/35k , 50k , 70k , 100k Tuner, Aux1, 2, Tape PB1, 2 : 150mV/50k Phono maximum allowable input(Harmonic distortion rate 0.1%, 1 kHz) Phono1:250mVPhono2 : 250 mV to 500 mVOutput Level / Impedance Tape Rec1, 2 : 150 mvPre-out : 2V/1k Harmonic distortion factor (20 Hz to 20 kHz) Not more than 0.05%Frequency characteristic Phono (RIAA deviation) : 30 Hz to 15 kHz ± 0.2 dBTuner, Aux, Tape PB : 7 7 hz to 40 khz + 0 to 1 dbTone control Bass: ± 10 dB (25Hz/50Hz/100Hz)Turnover Frequency : 100Hz/200Hz/400HzTreble: ± 10 db (8kHz/16kHz/32kHz)Turnover Frequency : 2kHz/4kHz/8kHzFilter Low : 15 Hz, 30 Hz, 12dB/oct.High : 8 kHz, 12 kHz, 12dB/oct.Muting 0, -15dB, -30dBS/N (IHF, A-networkShort circuit) Phono : 70 dB or moreTuner, Aux, Tape PB : 90 dB or higherSemiconductor used Transistor : 54FET : 2Diode, etc. : 26 pcsAC outlet Power switch interlock : 2 systemsPower switch not linked : 1 systemPower supply voltage 100 VAC, 50Hz/60HzPower consumption 190W (rated)530W maximumExternal dimensions Width 420x Height 165x Depth 403 mmWeight 17.2kg

Lisätiedot Ihan siisti ja täysin ehjä vahvari. Huolto tehty kesäkuussa 2022.100V japanilainen laite. Muuntaja mukaan.Euroopalainen versio Pioneer SA-8500 mkII.Model RatingType Stereo pre-main amplifierPower Amplifier UnitCircuit system 2-stage all-stage direct-coupled parallel PP pure complimentary service OCLEffective power(Both channel drive, 20 Hz to 20 kHz) 75W + 75W (4 )60W + 60W (8 )Harmonic distortion factor (20 Hz to 20 kHz) 0.05% (at effective output)0.01% (8 at 30W output)0.01% (8 at 1W output)Intermodulation distortion factor (50 hz : 7 khz = 4 : 1) 0.05% (at effective output)0.01% (8 at 30W output)0.01% (8 at 1W output)Output Bandwidth (IHF, both channel drives) 5 Hz to 45 kHz (Distortion Factor 0.05%)Frequency characteristic 5 Hz to 100 kHz + 0 -1dBInput Sensitivity / Impedance Power amp in : 1V/50k Output terminal Speaker A / B : 4 ~ 16 Speaker A + B : 8 ~ 16 Headphone : 4 ~ 16 Damping factor 30 (20 Hz ~ 20 kHz, 8 )S/N 110 dB (IHF, A-network, short circuit)Preamplifier SectionCircuit system Equalizer amplifier : First stage differential 3-stage direct connection Class A SEPPTone control section : first stage differential 2-stage direct connection flat amplifierTurnover 3-stage switching NFB-type toneInput Sensitivity / Impedance Phono1, 2 : 2.5mV/50k Cartridge Load Capacity : 100 pf, 200 pf, 300 pf, 400 pf (for both Phono1 and 2)Tuner, Aux, Tape play1, 2 : 150mV/50k Phono maximum allowable input Phono1, 2 : 250 mV (1 kHz, harmonic distortion rate 0.05%)Output Level / Impedance Tape rec1, 2 : 150 mVPre out : 1V/2k , 6V/2k (max)Harmonic distortion factor (20 Hz to 20 kHz) 0.02% (1 V Output)0.1% (6 v Output)Frequency characteristic Phono : 20 Hz to 20 kHz ± 0.2 dBTuner, Aux, and Tape play : 5 hz to 50 khz + 0 to 1 dbTone control Bass: ± 10 dB (25 Hz, 50 Hz, 100 Hz)Turnover frequency : 100 Hz, 200 Hz, 400 HzTreble: ± 10 db (8 kHz, 16 kHz, 32 kHz)Turnover Frequency : 2 khz, 4 khz, 8 khzFilter Low : 15 Hz, 6dB/oct.High : 8 kHz, 6dB/oct.Loudness contour(Volume -40dB) +6dB(100Hz)+3dB(10kHz)Muting -20dBS/N (IHF, A-networkShort circuit) Phono:75dBTuner, Aux, Tape play : 95 dBSemiconductor used Transistor : 47 Nos.Diode, etc. : 27 pcsAC outlet Power switch interlock : 2 systemsPower switch not linked : 2 systemsPower supply voltage 100 VAC, 50Hz/60HzPower consumption 150W (Electrical Appliance and Material Control Law)410W maximumExternal dimensions Width 420x Height 150x Depth 376 mmWeight 13.8kg